Before the DC geared motor is put into use, it needs to be systematically tested to facilitate future use. The following are the 4 test items before it is used.
1. Check whether the matching size of the hole (or shaft) connected with the DC gear motor meets the requirements. The tolerance of the hole should be H7 (the tolerance of the shaft is H6).
2. Replace the blockage at the highest position of the DC geared motor with the exhaust plug to ensure that the gas in the body is discharged when the DC geared motor is running.
3. Note that the operating temperature of the DC geared motor is 0-40°C.
4. The installation shaft should be cleaned before the machine is used. And check the installation shaft for bruises and dirt, and if so, clean them all up.
The above briefly introduces the 4 inspection items of the DC geared motor before use, and I hope it can be helpful to you.